Cub Cadet ZT-3400 - Manual (Page 12)

10 ZT-2800 ® /ZT-3100™/ZT-3400™
fiLTer and fiLTer gUard
Refer to Figure 4
disassembly
1. Remove the hex head screws (105), and
filter guard (106).
2. Remove the filter (23) and discard.
NOTE: Always replace the filter when perform-
ing any internal maintenance to the
transaxle.
3. Remove the metal oil drain plug (5) or the
fitting (111) from inlet port and allow any
remaining oil to drain from the transaxle.
inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
3. Fill transaxle with oil. Refer to “Fluid Change
Procedures,” page 11, steps 3 and 4 for filter
change instructions.
NOTE: As a general rule, use the low end of
the torque specification on fasteners
when reassembling the unit.
figure 4, filter and guard
When refilling the transaxle with oil,
remove the port plug (5), if installed,
and plug (11). Fill until the oil reaches the
lower lip of port (11) on side cover.
23
106
105
111
5
11
Units will have installed, the fitting (111)
or the plug (5).
Drain port
(for horizontal installation)