Cub Cadet ZT-3400 - Manual (Page 31)

ZT-2800 ® /ZT-3100/ZT-3400™ 29
figure 23, Bypass arm
Refer to Figure 23
disassembly
1. Requires removal of all items beginning on
page 22.
2. Remove the push-on retaining ring (35) and
discard. Remove the bypass arm (34).
3. Remove the retaining ring (33).
4. Remove the bypass rod (32) and the clip
retaining ring (31) as a single item.
NOTE: It is not necessary to remove the clip
retaining ring (31) from the bypass rod
(32) unless it is damaged or worn.
5. Remove the lip seal (30) and discard.
inspection
1. Inspect the bypass rod (32) for wear or dam-
age. Replace if necessary.
NOTE: Take care to insure that the bypass rod
is free of burrs that may cut the rubber
lip seal.
BYpass arM
assembly
1. Install a new lip seal (30).
2. Install the clip retaining ring (31) and bypass
rod (32).
3. Install the retaining ring (33).
4. Install the bypass arm (34) and new push-on
retaining ring (35).
35
31
34
33
32
30