Cub Cadet RZT-S Series - Manual (Page 20)

RZT-S
14
Control cable adjustment
To adjust the control cable:
1. Move the throttle lever to the detent between the full
throttle and the choke position.
2. Loosen the clamp that holds the control cable jacket
in position. See Figure 2.17.
3. Slide the cable jacket until the speed control lever
makes contact with the choke lever.
4. Tighten the control cable jacket.
5. Move the throttle lever to the choke position.
6. Verify that the choke is fully closed.
7. Test run the mower in a safe area before returning it
to service.
Figure 2.17
Speed control lever
Control cable clamp
Choke lever
Contact point