Cub Cadet RZT-S Series - Manual (Page 116)

RZT-S
110
3. Remove the idler bracket:
3a. Disconnect the idler spring. See Figure 7.12.
3b. Remove the nut, bolt and shoulder spacer that
hold the bracket to the deck.
4. Install the bolt that the pulley spins on in the idler
bracket.
5. Install the idler bracket So that the shoulder side of
the shoulder space is on the top side of the idler
bracket.
6. Attach the idler spring to the idler bracket.
7. Slide the belt guide onto the pulley bolt so that the
detect in the guide rests in the hole in the bracket.
See Figure 7.13.
8. Install the pulley and bearing cup.
NOTE: Wrap the belt around the pulley as it is low-
ered onto the pulley bolt.
9. Re-install the deck, if removed.
10. Test run the mower before returning to service.
Figure 7.12
Idler bracket
Spring
Figure 7.13
Hole
Detent