Cub Cadet RZT-S Series - Manual (Page 133)

Maintenance Intervals
127
3. Carefully slide the fuel lines off of the filter. If there are pieces of rubber on the barbs of the fuel filter, replace
the affected fuel line.
IMPORTANT: The RZT-S uses low permeation fuel line to meet EPA guidelines. When replacing the fuel
lines, they must be replaced with the same type of low permeation fuel line.
4. Install the new filter by following the above steps in reverse order.
5. Test run the engine and check for leaks before returning the mower to service.
Clean the engine
Air cooled engines cool better if they are clean. Check
for critter nesting or signs of nesting especially after dor-
mant season storage. See Figure 8.10.
Transmissions
The RZT-S is equipped with two Hydro-Gear EZT transmissions.
The maintenance procedures for the transmissions are located in the Hydro-Gear manuals. The Hydro-Gear
shop manual for the EZT transmissions is form number BLN-52622.
Figure 8.10
Mouse nest
Obstructed
air filter