BUCHI Pump Module C-605 - Manual (Page 27)

6 Operation
27 Pump Combinations Operation Manual, Version E
6 .2 Pump system 2, 3: Pump Manager C-615 and 1 - 2 Pump Modules C-601/605
Pump Manager C-615 can be operated with one or two Pump Modules C-601or one or two Pump
Modules C-605. Since the pump modules only differ with regard to the maximal pressure, they will be
described collectively.
ATTENTION
Note that two Pump Modules of different types must not be mixed.
6 .2 .1 Controls of the Pump Manager
1
2 4
3
a START button (green): Starts the pump
b STOP/PAUSE key (red): Press once for pause
mode; press again to abort
c Display: Displays parameters and values.
d Selector switch (lockdown switch): Operation of
menu by rotating and pressing.
Fig. 6.2: Control arrangement on the Pump Manager
6 .2 .2 Display
The display is divided into two areas. The first line (= status line) shows the status of the pump
module; it is fixed. The other lines display the parameters. The left column of the status line shows the
current mode of the pump modules.
There are three possible modes:
Stop: The pump modules are not running.
Pause: The pump modules are pausing. The time display is stopped. The program can be continued
at any time from the point at which it was paused by pressing the START button.
Pumping: The pump modules are pumping according to the set parameters.
The middle column of the status line shows the name of the running program and the number of the
current segment. The latter is not displayed during manual operation. The right column displays the
time. The upper value indicates the remaining time until the end of the program and the lower indi-
cates the remaining time of the current segment.
The bottom lines contain the current parameters of the pump module. The scroll bar on the right
shows where you are within the menu display.