BUCHI Rotavapo R-100 - Manual (Page 30)

6 | Operation BÜCHI Labortechnik AG
30/60 Operation Manual Rotavapor® R­100
6.1.4 Fitting the receiving flask
Materials required:
— Grease Glisseal 40 blue (order number 048197)
u Apply a thin coat of Grease Glisseal 40 blue to the ground joint of the receiving
flask.
u Fit the receiving flask (3) onto the condenser from below and secure it with the ball
joint clamp (2).
6.1.5 Vertical adjustment
2
3
1
The rotary drive unit together with the glass components can be raised or lowered in
the following ways:
— Using the handle (1), the evaporating flask can be lowered into and lifted out of the
heating bath (see Chapter 6.2.1 "Raising and lowering the evaporating flask", page­
33). To prevent the evaporating flask and the vapor duct from colliding with the
heating bath, a lower stop can be set using the screw­handle (2).
— If an especially large evaporating flask or a long vapor duct is being used, the entire
vertical adjustment range can be moved up or down by means of screw­handle (3)
(see Chapter "Moving the vertical adjustment range up/down", page 31).