BUCHI Rotavapo R-100 - Manual (Page 25)

BÜCHI Labortechnik AG Installation | 5
Operation Manual Rotavapor® R­100 25/60
5.6 Electrical connections
u Make sure that the available power supply matches the rating indicated on the type
plate.
u Plug the rotary drive unit connecting lead into the socket (2) on the heating bath.
u Plug the power cord into the socket (1) on the heating bath and then into a mains
power socket.
u If an extension lead is required, make sure that it is earthed and has a suitable
power rating.
5.7 Overview of connections
The diagram below shows the connection of tubing and electrical leads in a typical ap­
plication of the Rotavapor® R­100 in conjunction with a Recirculating Chiller F­105, a
Vacuum Pump V­100, an Interface I­100 and a Woulff bottle (see also Chapter 3.2.4
"Typical application", page 14).
IN OUT
The connections to the Recirculating Chiller F­105, the Vacuum Pump V­100 and the
Interface I­100 are described in the particular operating instructions in each case.