Aviom A-16R/A-16CS - Manual (Page 70)

61 A-16R P
eRsonAl
M
ixeR And
A-16Cs C
ontRol
s
uRfACe
u
seR
G
uide
Troubleshooting
Before contacting Customer Service, check the following list of common
problems and solutions for help.
Problem: Nothing happens when editing from the front panel of the A-16R.
Or, nothing happens when trying to edit the A-16R remotely using an A-16CS
Control Surface.
Possible Solutions:
The • R
emote
/l
ocal
switch on the right side of the A‑16R
determines which device is active for editing.
When using an A‑16CS, make sure that the
• A‑Control cable
is connected to the A‑Control jack found on the rear panel
of the A‑16R.
Note that only one device can edit an A‑16R at a time.
Problem: No audio from Personal Mixer outputs
Possible Solutions:
No input audio from the main mixing console. Check •
the levels of the main mixing board that the system is
connected to.
Check the cables and connections between the main
•
mixer and the personal monitor system. The Signal LEDs
on the front of Pro16 analog input modules can be used to
confirm that audio is being received.
Check channel routing if using a console interface card as
•
the system’s input module.
Bad cables; try a replacement.
•
All channels on the Personal Mixer are at zero. •
Master volume level on the Personal Mixer is at zero. •
A‑Net cables are not connected properly. •