Aviom A-16R/A-16CS - Manual (Page 41)

32 A-16R P
eRsonAl
M
ixeR And
A-16Cs C
ontRol
s
uRfACe
u
seR
G
uide
without affecting the other components of the Group. The changes you
make to volume and pan affect only the selected channel, allowing you to
change the relative balance of the individual components of your Group.
Changes can be made in real time.
To select a different channel in a Group for editing, press one of the flashing
LEDs (don’t double‑click it). The new selection will light its LED solid, while
the previously selected channel will start to flash. Continue making changes
as needed. Remember, volume and pan changes only affect the channel
whose LED is lit solid. Press the G
Roup
button again to exit Group Mode. Save
the mix Preset.
11 22 33 44 55 66 77 88 99 11 00 11 11 11 22 11 33 11 44 11 55 11 66
Sa
ve
AA--1166RR
Personal Mixer
Solo
Mute
In Recall Mode - All Volumes Zero
Recall
Group Phones
MIDI On
Local
Remote
MIDI Off
M
ut
e
Se
le
ct
M
ut
e
Se
le
ct
M
ut
e
Se
le
ct
Mix In Bass Treble
Master
Volume
Volume
Pan
A-Net
Active
_ + _ +
One channel in a Group is always available for editing, indicated by a flashing
LED; press any other channel in the Group to change its pan or volume.
Removing Channels From a Group
When in the Group edit mode (the Group LED is flashing), changes can be
made to the channels included in existing Groups. To remove a channel
from a Group, simply double‑click the channel that you want to remove. The
flashing LED will go out. To add other channels to a Group, double‑click them.
When you have double‑clicked to remove all channels that were previously
part of the Group you’re editing, the Group will no longer exist. You need at
least two channels to have a valid group.
Exit the Group edit mode by pressing the G
Roup
button again. The LED in the
Group button will go out. This saves your changes to the Group. Save the mix
Preset to retain the settings for recall later.