beautypg.com

Configuring hsrp on the gatekeeper example – Cisco H.323 VC-289 User Manual

Page 61

background image

Configuring H.323 Gatekeepers and Proxies

H.323 Gatekeeper Configuration Examples

VC-349

Cisco IOS Voice, Video, and Fax Configuration Guide

Gatekeeper gk-sj checks for a technology prefix match but does not find one. It then searches for a zone
prefix match and fails again. But there is a match for default gateway prefix of 4#, and gw-sj4 is
registered with 4#, so the call is routed out on gw-sj4.

Configuring HSRP on the Gatekeeper Example

This sample configuration uses Ethernet 0 as the HSRP interface on both gatekeepers.

On the primary gatekeeper, enter these commands:

configure terminal

! Enter global configuration mode.

interface ethernet 0

! enter interface configuration mode for interface ethernet 0.

standby 1 ip 172.21.127.55

! Member of standby group 1, sharing virtual address 172.21.127.55.

standby 1 preempt

! Claim active role when it has higher priority.

standby 1 timers 5 15

! Hello timer is 5 seconds; hold timer is 15 seconds.

standby 1 priority 110

! Priority is 110.

On the backup gatekeeper, enter these commands:

configure terminal

interface ethernet 0

standby 1 ip 172.21.127.55

standby 1 preempt

standby 1 timers 5 15

The configurations are identical except that gk2 has no standby priority configuration, so it assumes the
default priority of 100—meaning that gk1 has a higher priority.

On both gk1 and gk2, set up identical gatekeeper mode configurations, as follows:

configure terminal

! Enter global configuration mode.

gatekeeper

! Enter gatekeeper configuration mode.

zone local gk-sj cisco.com 172.21.127.55

! Define local zone using HSRP virtual address as gatekeeper RAS address.

.

.

.

! Various other gk-mode configurations.

no shut

! Bring up the gatekeeper.

configure terminal

! Enter global configuration mode.

gatekeeper

! Enter gatekeeper configuration mode.

zone local gk-sj cisco.com 172.21.127.55

! Define local zone using HSRP virtual address as gatekeeper RAS address.

! Note this uses the same gkname and address as on gk1.

.

.

! Various other gk-mode configurations.

no shut

! Bring up the gatekeeper.