Cisco H.323 VC-289 - Manual (Page 50)

Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-338
Cisco IOS Voice, Video, and Fax Configuration Guide
Step 3 Router(config-if)# ip address ip-address mask
[secondary]
Sets a primary or secondary IP address for an
interface.
The keywords and arguments are as follows:
• ip-address—Specifies the IP address.
• mask—Specifies the mask for the associated IP
subnet.
• secondary—(Optional) Specifies that the
configured address is a secondary IP address. If
this keyword is omitted, the configured address is
the primary IP address.
Step 4 Router(config-if)# h323 interface [port-number] Signals the proxy that this interface IP address is the
one to use.
For an explanation of the arguments, see Step 3 in the
configuration task table in the
“Configuring a Proxy
Without ASR” section on page 333 .
Step 5 Router(config-if)# h323 h323-id h323-id Configures the proxy name. (More than one name can
be configured if necessary.)
The h323-id argument specifies the name of the
proxy. It is recommended that this be a fully qualified
e-mail identification (ID), with the domain name
being the same as that of its gatekeeper.
Step 6 Router(config-if)# h323 gatekeeper [id
gatekeeper-id] {ipaddr ipaddr [port] | multicast}
Specifies the gatekeeper associated with a proxy and
controls how the gatekeeper is discovered.
For an explanation of the keywords and arguments,
see Step 5 in the configuration task table in the
“Configuring a Proxy Without ASR” section on
page 333
.
Step 7 Router(config-if)# h323 qos {ip-precedence value |
rsvp {controlled-load | guaranteed-qos}}
Enables quality of service (QoS) on the proxy.
For an explanation of the keywords and arguments,
see Step 6 in the configuration task table in the
“Configuring a Proxy Without ASR” section on
page 333
.
Step 8 Router(config-if)# interface type number [name-tag] If ASR is to be used, enters the interface through
which outbound H.323 traffic should be routed.
For an explanation of the keywords and arguments,
see Step 2 in the configuration task table in the
“Configuring a Proxy Without ASR” section on
page 333
.
Command Purpose