Cisco H.323 VC-289 - Manual (Page 56)

Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-344
Cisco IOS Voice, Video, and Fax Configuration Guide
Step 9 Router(config-if)# h323 asr [bandwidth
max-bandwidth]
Enables ASR and specifies the maximum bandwidth
for a proxy.
The optional max-bandwidth argument specifies the
maximum bandwidth on the interface. Value ranges
are from 1 to 10,000,000 kbps. If you do not specify
max-bandwidth, this value defaults to the bandwidth
on the interface. If you specify max-bandwidth as a
value greater than the interface bandwidth, the
bandwidth will default to the interface bandwidth.
Step 10 Router(config-if)# ip address ip-address mask
[secondary]
Sets up the ASR interface network number.
For an explanation of the keywords and arguments,
see Step 3 in this configuration task table.
Step 11 Router(config-if)# exit Exits interface configuration mode and returns to
global configuration mode.
Step 12 Router(config)# interface type number [name-tag] Enters interface configuration mode on a non-ASR
interface.
For an explanation of the keywords and arguments,
see Step 2 in the configuration task table in the
“Configuring a Proxy Without ASR” section on
page 333
.
Step 13 Router(config-if)# ip address ip-address mask
[secondary]
Sets up a non-ASR interface network number.
For an explanation of the keywords and arguments,
see Step 3 in this configuration task table.
Step 14 Router(config-if)# exit Exits interface configuration mode.
Step 15 Router(config)# router igrp autonomous-system Configures Interior Gateway Routing Protocol
(IGRP) for a non-ASR interface. The
autonomous-system argument specifies the
autonomous system number that identifies the routes
to the other IGRP routers. It is also used to tag the
routing information.
Step 16 Router(config)# network network-number Includes a non-ASR interface in an IGRP domain.
The network-number argument specifies the IP
address of the network of the directly connected
networks.
Step 17 Router(config)# network network-number Includes a loopback interface in an IGRP domain.
The network-number argument specifies the IP
address of the network of the directly connected
networks.
Step 18 Router(config)# router igrp autonomous-system Configures IGRP for an ASR interface. The
autonomous-system argument specifies the
autonomous system number that identifies the routes
to the other IGRP routers. It is also used to tag the
routing information.
Command Purpose