Panasonic OMNIVISION PV-M2057 - Manual (Page 36)

Timer Recording
Your Combination VCR can be set up to
do a recording while you are away or
otherwise occupied. Up to 8 programs
can be placed in memory. You can
choose to record one time, daily, or
weekly.
Check list before you begin.
□ All connections are made (see page 5).
□ Your Combination VCR is plugged in.
□ The clock is set.
□ The tape is long enough.
□ The record tab is in place.
□ TV GUIDE Plus+ is not activated/setup.
STOP/EJECT PROGRAM TIMER
Indicator
a
d
STOP
Push PROG to display
the program screen.
•When the TV GUIDE Plus+
feature is setup, the Timer
Recording function as indicated
below will not operate. In order
for the Timer Recording function
to operate, the TV GUIDE Plus+ must be
de-activated by re-setting all Combination
VCR memory functions (see page 41.)
If a program is already in memory, pushA Trepeatedly,
and then Oto select an unused program number.
Push
m.
¥ and Oto select and
set one of the following:
1 = One time recording
DAILY = Same time MON - FRI
WEEKLY = Same time once a week
Example ■31— 1 —2’
Today's
Date
1^8—9-
, 7 SELECTA/T Selection Order DAILY
L^WEEKLY........... WEEKLY___ WEEKLY _J
(SAT) (MON) (SUN)
(I)
Push A ¥and 0 [>to
select and set each of
the remaining items at
right.
To Make Corrections
Repeatedly pushOor^^to move the cursor to
the right or left, and then make the correction.
Remaining items:
• START time
• STOP time
• CH(annel) number,
or LINE for outside
source recording
• Speed (SP, LP, SLP)
Push PROG to end the
program.
• This screen appears for
confirmation.
To Enter More Programs
Push A V and select and set a blank
program number, and then repeat steps 2 and 4.
P DT START STOP CH SPD
2----------------
3 ------------
4 ------------
CANCEL
SELECT
ETTTER
END
ADD/DL
1 - 8 : A
► KEY
PBOG f
T KEY
▼ KEY
CEY
Push PROG to exit this mode and return to
the normal screen.
• The PROGRAM TIMER indicator lights on the front panel.
• If you’re using a cable box, make sure that it is tuned to the
desired channel and the power is left on for timer recording.
Two minutes before the Timer Recording starts, “TIMER REG WILL
START SOON” will appear on-screen.
36
Timer Recording will not function if TV GUIDE Plus+ is setup.
If “PLEASE PREPARE FOR TIMER REC" appears and/or the PROGRAM TIMER indicator flashes, check that a
cassette with record tab is loaded and the Combination VCR is in Stop mode.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 35), the timer
recording will not be performed.
If there is a power interruption of more than one minute, the recording may not be performed or continue.
If “INCOMPLETE" appears after all items have been set, check all entries and make necessary corrections.