Panasonic OMNIVISION PV-M2057 - Manual (Page 27)

On-Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear for a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.), the
Combination VCR mode will
be displayed.
• When a recording is started, both REC and
the channel number will appear together.
Menu Screen
Push MENU to display
the MAIN MENU.
Push A t OI> and
MENU to make your
selection (see page 8).
MAIN MENU
U^AGE
SELECT : A T ► KEY
SET :MENU KEY
To get the most from
each feature, please read the
Operation Manual before
attempting any operation.
Warning and Instruction Displays
These displays will alert you of a missed operation or provide
further instructions.
If no active channels are found
for CHANNEL MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Recording
or set the on-timer and
the Clock is not set...
(see pages 8, 9.)
If a Timer Program was not
completed before exiting the
Program mode...
(see pages 36, 37.)
If you push REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 41.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
DATE START STOP CH
SLP
SET ► KEY
END :PflOG KEY
CHECK CASSETTE
RECORD TAB
VCR Status & Clock Display
Push DISPLAY to display and remove
the overlay shown below.
Function Status
Rec Time
Remaining
(OTR mode only
see page 35.)
Receivable
Broadcast Types
(See page 38.)
REC 12:00AM WNET-
— 0:25 0 00:00
»STEREO 1
»SAP
MONO
Current Time
Channel &
Call Letter
Tape Speed
Tape Counter
If you push STOP during a
Timer Recording...
(see page 37.)
If you push PLAY, FF, REW, or
REC on the remote control or
the Combination VCR without a
cassette inserted...
(see pages 33-35.)
If the Combination VCR is not in
Stop mode or a cassette with
record tab is not inserted two
minutes before a Timer
Recording is about to begin...
(see pages 36, 37.)
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE PREPARE
FOR TIMER REC
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no broadcast
signal, the TV screen will turn a solid blue.
If head cleaning becomes
necessary while playing
back a tape...
(see page 41.)
VIDEO HEADS MAY
NEED CLEANING
PLEASE I NSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
If you push a function button
other than STOP/EJECT or
POWER while the
Combination VCR is in VCR
Lock mode...
(See page 39.)
VCR LOCK ACTIVATED
27