Panasonic SC-DV100 - Manual (Page 17)

loiscil [DISC il lOISC 31 lDÍ5C4l [DISC 5l
n n r l< I ~i
, I I r C ! >1 D
© Label must
face upward.
Always stop the changer before loading or changing discs. You can­
not change discs while a disc is playing.
H
Press [DIRECT OPEN, DISC1 ]-[DISC5], which­
ever you want to open.
Insert a disc in the tray.
Repeat steps Q-Q to load the other trays.
Q Press OPEN/CLOSE].
If “DVD" is selected as the input source and a DVD or video CD
with PBC is inserted, the Automatic Play function is activated.
{Refer to the following article)
How to load discs \
Disc indicators (DISCI-DISCS)
These indicators light green to show a tray is in the playing position,
whether it is loaded or not.
To prevent damage
Always observe the following points.
•Load only 1 disc per tray. H
• Load discs as shown in figure. B
An adapter is not needed with 8 cm discs (singles).
• Set the system on a flat, level surface.
Do not set it on top of magazines, inclined surfaces, etc.
• Do not move the system while trays are opening/closing, or when
loaded.
Always unload all trays before moving the system.
• Do not put anything except discs in trays.
• Do not use cleaning discs or discs which are badly warped or
cracked.
• Do not use discs with poorly attached labels or stickers. Adhesive
protruding from underneath stickers or left over from peeled off
stickers can cause the system to malfunction.
• Do not use irregular shaped discs. H
Automatic Play function
Most DVDs and video CDs with PBC start playing if any of the follow­
ing operations is performed:
• [^ OPEN/CLOSE] is pressed to close the tray after inserting a disc.
•The power is turned on when a disc is in the changer and the input
selector is set to DVD.
•“DVD" is selected with [INPUT SELECTOR] on the unit or [DVD] on
the remote control when a disc is in the changer.
Press [■] to stop the disc if play starts while setting the timers or
preparing to make a recording.
WJ
C .0
£
5
0)
6
Q
I
0
ui
Q
1
Q
RQT5056