Panasonic CT-36SF24 - Manual (Page 15)

Special Functions
Recall Button
Press the RECALL button to review:
(T) Audio Mode status
@ CH number or Video Input selected
@ Channel Caption (Station Identifier)
( 4 ) Clock time
@ Sleep Timer status
© ®
Multi Button
The MULTI button can be programmed to operate up
to six (6) remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On, and
Cable Box Power/On (selected brands) can be operated
at the same time with one press of the MULTI button.
(The VCR Mode button should be programmed
before starting procedure).
Procedure
1. Program the Rennote for the selected device Infrared
access code. Confirm that the Remote Control is
compatible with the device.
Face the Remote Control transmitter away from all
equipment remote sensors.
Press and hold the Remote Control POWER button,
then press and hold the ACTION button down
simultaneously for three seconds. (All previous
commands are erased.)
2 .
3.
PRESS SIMULTANEOUSLY FOR
THREE SECONDS
4.
5.
6 .
R-Tune Button
Pressing the R-TUNE (RAPID TUNE) button toggles to
the previously tuned program.
After three seconds, release the POWER and
ACTION buttons.
Press the MULTI button. (Waiting more than 30
seconds without pressing another button will exit the
programming mode.)
Press a maximum of six (6) function buttons on the
Remote Control.
Each button pressed is equal to one function. If six
(6) Remote button functions are entered, all will
register in the MULTI button memory in the
sequence entered. When finished, press the MULTI
button to exit the programming mode.
The following is an example flow chart of remote
functions that can be programmed into the MULTI
button.
PROGRAM
CURRENTLY VIEWED
PROGRAM
PREVIOUSLY VIEWED
Press Button
Press Button Again
Helpful Hints:
Press the TV Mode Selection button to operate TV
Remote functions, if necessary.
You can now turn the TV and VCR ON/OFF at the
same time with one press of the MULTI button.
To delete entered functions - Press and hold the
Remote Control POWER button, then press and
hold the ACTION button down at the same time for
three seconds. You can now enter from one to six
different Remote functions.
NOTE: You can also program the MULTI button to
perform most individual Remote Control button
functions. Buttons which continuously perform a
function as long as pressed (Volume Up/Down,
Channel Up/Down, etc.) cannot be programmed;
only those buttons which perform a function
when initially pressed (Power On/Off, Mute,
Direct Channel Entry, etc.) can be programmed.
- 1 5 -