Panasonic DVD-RV80 - Manual (Page 41)

DVD
No subtitles. Subtitles appear only with discs which contain them.
Subtitles are cleared from the TV monitor. Display the subtitles. © ©
Alternative soundtrack (or
subtitle) languages fail to be
selected. An alternative language is not selected with discs which do not contain more than one language.
In the case of some discs, the alternative language cannot be selected by operating the [AUDIO] or
[SUBTITLE]. Try selecting it from the disc's menu if one is available. ©
Angle cannot be changed. This function is dependent on software availability. Even if a disc has a number of angles recorded,
these angles may be recorded for specific scenes only (when “ANGLE" lights up on the player’s FL
display).
Soundtrack and/or subtitle
language is not the one selected
at the initial settings. If the soundtrack and/or subtitle language does not exist on the disc, the language selected at the
initial settings will not be seen/heard.
The disc’s menu is displayed in
French (example).
The setup “3 Menus" of “1 Disc Languages” is set to French: Select English. ®
Sound does not come from a
speaker.
Check the connections. © ©
If you have connected this player to an amplifier through the audio output terminals, go to the initial
settings menu “8 Speaker Setting” and change the settings to suit your speakers. Select “Yes" for all
the speakers you have connected. ©
DVD-RV60 cannot decode DTS encoded discs. To enjoy DTS encoded discs, connect to an •
amplifier that has a DTS Digital Surround decoder. ©
If you have connected this player to an amplifier (with built-in decoder) through the digital audio
output terminal, go to the initial settings menu "7 Digital Audio Output” and change the settings to
“Bitstream" for “2 Dolby Digital" or “3 DTS Digital Surround". ©
Sound will only come from the two front speakers if V.S.S. is on. Turn V.S.S. off. ©
The password for rating level has
been forgotten.
Reset all the settings to Factory
Preset.
White stopped, press and hold [K4] and [II] on the player and then also press and hold [^OPEN/
CLOSE] on the player until “Initialized” disappears from the television (after about 3 seconds).
All initial settings will return to the default values.
The vocals cannot be turned off. You have selected an audio channel that includes a vocal channel. Read the disc’s jacket to choose
the correct channel. ©
A menu is shown after playing
each song on a Karaoke DVD. Most Karaoke DVDs are designed to do this. Some discs have an item in the menu that allows you
to play all the songs.
Video CD
o>
o
c
Si
•Si
0)
QC
3
2
£
No menu play. This function works only for Video CDs with playback control. ©
Self-diagnosis display function
When an error or trouble is detected during operation, a message appears in the FL display.
When a message has appeared, check the details given below.
Message Player status Remedy
CHECK THE DISC Disc is dirty. Wipe the disc clean.
HDD
□□ stands
for a number.
Trouble is likely to have occurred. The
number following “H” differs depending on
the status of the player.
Press [POWER (!)/!] to switch the player to the standby mode and
then back to ON. Alternatively, press [POWER ci)/l] to switch the
player to the standby mode, disconnect the AC power supply cord,
and then reconnect it.
• If the message fails to be cleared, even when remedial action is taken, ask a service technician to repair the player.
VQT0621