Panasonic Panafax UF-270 - Manual (Page 95)

Setting Up Your Machine for Relayed Transmission
To set up your machine for Relayed Transmission, use the procedures on the following pages to
set the eight parameters listed below. Some parameters (e.g„ Relayed XMT Fax Parameter) are only
set once, but others must be set separately for each station in the Relay Network.
1. Relayed XMT Fax Parameter:
This switches the Relayed XMT function ON or OFF.
2. Own Telephone Number:
Your full telephone number should be entered.
3. Network Address:
End Receiving station telephone numbers set in an initial Sending station may be different from the
.numbers set in a Relay Station. To send a fax to an End Receiving station via a Relay Station each
station in the network must be identified with a certain code which does not vary depending on where
you call from. The code is the Network Address, which consists of a four-digit number and is as­
signed to a One-Touch/ABBR number,
4. Network Password:
A four-digit number which prevents unauthorized (outside) stations from accessing the Relay Station
and using its memory. Every station in the network should set the same Network Password.
5. One-Touch/ABBR Numbers:
The One-Touch or ABBR number you set must represent the fax number of a particular station in
the network as seen from your station.
6. Relay Station Parameter (Yes/No):
Set "Yes” if the particular station you are recording is a Relay Station. If you are connected to more
than one Relay Station In series, set “YES” only for the first Relay Station.
7. Relay Address:
A two-digit number which identifies the Relay Station your machine will use. Your machine may be
connected to more than one Relay Station in parallel, but when you use Relayed XMT your machine
will only send documents to the Relay Station identified by the Relay Address.
8. One Station XMT (Relay/Direct) Parameter:
If you send a document to only one End Receiving Station, you can set your machine to transmit
directly to that station, without going through the Relay Station, by selecting “Direct.” Set “Relay”
if you always want to go through the Relay Station.
9. Substitute Relay Station:
If more than one route between your machine and one or more End Receiving Stations is estab­
lished in the network, that is, if a second Relay Station is connected in parallel or the Relay Address
is not set properly, your machine will not be able to decide which Relay Station to use. If, however,
you preset one of the two Relay Stations as a Substitute Relay Station, your machine will transmit
to it whenever the regular Relay Station cannot be reached.
94