Panasonic CQ-DF201U - Manual (Page 25)

Troybiesiliitin
Preliminary Steps
Check and take steps as described in the tables below.
If You Suspect Something Wrong
Immediately switch power off.
Disconnect the power connector and check that there is nei­
ther smoke nor heat from the unit before asking for repairs.
Never try to repair the unit yourself because it is dangerous to
do so.
Troubleshooting Tips
□ Common
Trouble
Cautions:
© Do not use the unit if it malfunctions or
is something wrong.
o Do not use the unit in abnormal condi­
tion, for example, without sound, or
with smoke or foul smell, can cause ig­
nition or electric shock. Immediately
stop using it and call the store where
you purchased it.
No power.
No sound.
□ Radio
Trouble
Much noise in FM stereo
and monaural broad­
casts.
Preset station is reset.
Cause/Step
Car’s engine switch is not on.
i=>Turn your car’s ignition switch to ACC or ON.
Cables are not correctly connected.
«^Connect cables correctly.
Battery cable is not correctly connected.
<=>Connect the battery cable to the terminal that is always live.
Accessory cable is not correctly connected.
^Connect the accessory cable to your car’s ACC source.
Grounding wire is not correctly connected.
>=>Connect the grounding wire to a metal part of the car.
Fuse is burnt.
^Call the store where you purchased the unit, or your nearest service
station (see the attached sheet) and ask for fuse replacement.
Mute is set to ON.
»Set it to OFF.
J
Cables are not correctly connected.
»Connect cables correctly.
J
f
Condensation (dew)
....
»Wait for a while before use.
\__________________________________________________________ J
Cause/Step
Station Is too far, or signals are too weak.
»Select other stations of higher signal level.
\__________________________________________________________ J
Battery cable is not correctly connected.
»Connect the battery cable to the terminal that is always live.
msmm
25