General, Power, Volume – Panasonic cq-dpg55len User Manual
Page 31: Super high definition bass о s * hdb button, Attenuator, Bass and treble, Balance, Fader, Sound memory (only for remote control), Changing sound memory
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Operating Procedures
Aim the remote controller toward the sensor of
the main unit.
General
Power
® PWR (Power Button)
Press PWR to switch on the power.
Press PWR again to switch off the power.
s________________________________________ >
Mode Selection
О
MODE (Mode Button)
Press MODE to switch the operation mode in the
following order.
Tuner ^ CD Player
^
(CD Changer Control)
___________ -___________J'
---------------------------------------------------------------------------------------------------------^
^
Volume
VVOLA (Volume Control Button)
Press “A” or “V” to increase or decrease vol-
. ume level.
''---------------------------------------------------------------------
Super High Definition Bass
О s
* HDB Button
• Press (S • HDB) to be able to listen to
high-definition bass.
• Press the same button again to cancel.____
Attenuator
Ф ATT Button
• Press ATT to decrease volume to about 1/10
of the previous level.
• Press ATT again to cancel.
Changing Audio Modes
9
SEL (Select Button)
Press SEL to switch the audio control mode in
the following order.
Normal Mode # VOL
^
BAS4TRE4BAL# FAD
t__________________Mr
Bass and Treble
9
VVOLA (Volume Control Button)
Press SEL to select the BASS (TREBLE) mode.
Press “VOLA” or “VVOL” to increase or
decrease the bass (treble) response.
V_______________________________________ y
--------------------------------------------------------------------------------------------------- N,
Balance
ill VVOLA (Volume Control Button)
Press SEL to select the BALANCE mode. Press
“VOLA” or “VVOL” to shift the sound volume
to the right or left speakers.
'________________________________________________ _______ _______________^
■“
■■
~
-s
Fader
® VVOLA (Volume Control Button)
Press SEL to select the FADER mode. Press
“VOL A” or “VVOL” to shift the sound volume
to the front or rear speakers.
Sound Memory
(Only for Remote Control)
Changing Sound Memory
0 SDM (SDM Button)
Press SDM to switch the sound memory in the following order.
Initial ^ SOUND 0 ■►SOUND 1 ^ SOUND 2 ^ SOUND 3
t_______________________ *
Sound memory settings are as follows.
BAS
TRE
BAL
FAD
S»HDB
SOUND 0 (at Initial)
0
0
Center
Center
OFF
SOUND 1 (On expressways: recommended)
+6
+3
Center
Center
OFF
SOUND 2 (Vocal emphasized)
-6
-6
Center
Center
OFF
SOUND 3 (Bass emphasized)
0
+3
Center
Center
ON
Notes: Desired sound memory input:
• If SDM is pressed at SOUND 0,1, 2, or 3 after changing BAS, TRE, BAL, FAD, or S*HDB settings, the
selected condition is stored in the memory of “SOUND 0”.
• When “SOUND” is not displayed, press SDM to show current SOUND mode.
Mode change is valid only when “SOUND” is displayed.
CQ-DPG55LEN
31