Panasonic cq-dpg55len - Manual (Page 21)

Initial Time Setting
Press BAND to change to AM mode.
© Press DISP. “NO Cr is displayed.
© Press and hold DISP again for more than 2 seconds, "hours” blinks
indicating the time setting mode is activated.
© To set hours, press “TUNE A or VTUNE”.
0 Press DISP again for minutes setting.
0 To set minutes, press TUNE A or VTUNE.
Hold “ A” or “ V” change numbers rapidly.
® When set the time, press DISP.
Notes:
• If CT display is kept on, it remains on even if PWR and ACC are tuned
off and back on again.
• In CD Changer mode, press and hold DISP for more than 2 seconds
(In FM, CD mode, press DISP) to get RDS CT-service.
B. TP Reception
Select traffic information (TA on) mode
Press TA to switch ON and keep it there when you wish to listen to traffic
information. Press TA to switch OFF when no traffic information is need­
ed.
Volume Setting (Only for CD/CD C TA on mode)
Adjust the volume as desired using “VOLA” or “V VOL” while receiving
traffic announcement. (TA)
After volume for traffic announcement (TA) is set, the glifference
between normal volume and TA volume is automatically stored in the
memory (up to 5 levels) so that next traffic information will be received
at the preceding TA volume which may be higher or lower than normal
volume.
Normal volume can be changed up to 5 levels upward or downward.
If an adjusted level of volume is over 40 or less than 0, any further
change will not be made.
When receiving a station other than TP station (includ­
ing EON stations)
A traffic information station is automatically searched for and the radio
automatically stops the next available TP station. EON Capabilities:
EON lets the radio take advantage of much more RDS information than
before. It constantly updates the AF lists for all switch presets far from
home, you will receive an alternative frequency for the same station, or
another station carrying the same program, when such exists. EON also
keeps track of locally available TP station.
Press TA.
CQ-DPG55LEN
21