Panasonic LF-D102U - Manual (Page 12)

□ Rear panel of this DVD-RAM drive
iP-
TERMINATOR
SCSI ID
1 2 4
SCSI
(ШШД1
^ POWER
n ®
ON
r~
tr
Al
ON
OFF SCSI
IT
оШ 2Ш 4Ei 5H 6И тШ
DC IN5V.12V
“4”
^oyoijyij ™
“5”
“2”
“6”
yOOULlUl™
“3” toiuui™.
ily
Function switch settings в
О О О SCSI ID setting
OTerminator setting
© © Factory default only (OFF)
----------------------------------------------------
f--------------------------------------------------------------\
E3 Terminator setting H SCSI ID setting (Factory Default; 4)
(Factory Default; ON) SCSI IDs are a number identifying each SCSI
A terminator refers to a terminating resistance. unit. Consequently, SCSI IDs must be set so
The terminators must be set properly when that no two units duplicate each other on the
SCSI units (including the DVD-RAM drive) have SCSI bus.
been connected to the computer.
Note:
• When the DVD-RAM drive is a terminating Generally, the SCSI IDs are set as follows;
device (for example, illustration © on page • Hard disk drive: 0
11) • CD-ROM drive: 3
Set to ON. • SCSI host adaptor: 7
• When the DVD-RAM drive is not a terminating
Check the SCSI ID (refer to devices instruction
device (for example, illustration ®-© on page
11)
Set to OFF.
manual) for each device connected on the SCSI
bus.
Set the DVD-RAM drive’s ID so as not to
duplicate any other device’s ID.
V --............................... ... -.----------------- J ^..-............ .............. ^
12