Midi setup, Program change table edit, And program change table edit – Yamaha FX500B User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

• MIDI Setup

This function makes it possibie to select any of the four

available program change table BANKs, and to change the

MIDI receive channel for each BANK.

M I D I S E T U P

B B H K

! a

c h = 0 M N I

(D The underline cursor should be under the BANK

parameter. Use the

and Tkeys to select the bank

you wish to program (A, B, C or D).

@ Move the cursor to the "ch=" parameter by pressing the

PARAM (^) key, then use the Aand Tkeys to set the
receive MIDI channel (1 —16), the OMNI mode (all

channels can be received), or turn MIDI reception OFF

for the selected barik. The underline cursor can be

moved back to the BANK parameter if necessary by

pressing the MEMORY ('^) key.

• Program Change Table Edit

When this function Is called the LCD will appear as shown

below, and it becomes possible to assign new memory

location numbers to each MIDI program change number.

display. The underline cursor should be under the PGM

parameter.

j M I C' I

F' G M c: H PI hi Q E

pen

i = MEM 1

number to which a new FX500B memory location
number is to be assigned. The range of available

program change numbers is from 1 to 128.

pressing the PARAM (>■) key. Use the Aand Tkeys to
select the memory location number containing the

effect which is to be assigned to the currently selected

program change number,

i f i s selected, no new memory location will be

selected when that program number is received.

by pressing the MEMORY (^) key and repeat the

above steps to assign as many program change

numbers as necessary.

NOTE: The program number/memory number

assignments made are stored in the BANK
selected In the previous MIDI Setup function. To

program the program change/memory number

assignments for a different BANK, return to the
MIDI CONTROL display, select the desired BANK,

then program the required assignments.

NOTE: Although the BANK A, B, and C program change

tables are retained in memory even when the

power is off, the BANK D program change table is
automatically initialized whenever the FX500
power switch Is turned on (PGM number - MEM

number). Make sure you program PGM/MEM

assignments you want to keep in BANK A, B, or

■

MIDI Parameter Control: Control

Change 1 Table Edit and Control
Change 2 Table Edit

The FX500B allows two MIDI ’controllers” to be assigned

for remote real-time control of effect parameters. ’MIDI

controller’ actually refers to a MIDI CONTROL CHANGE

number between 0 and 127. Some of these numbers are
assigned to specific controllers — modulation wheel, data

entry, etc— and a MIDI device such as a keyboard or
MFC1 MIDI Foot Controller that has the any of these

controllers will transmit the corresponding MIDI control

change data when the controllers are operated. You could,

for example, assign an FC7 connected to an MFC1 to

control the FX500B reverb time.