Yamaha FX500B - Manual (Page 10)

5. The MEMORY Mode: Selecting Effect Programs
In the FX500B MEMORY mode, the
A
and Tkeys can be
used to select individual effect programs. When a new
program number is seiected, its number will flash on the
display and its title Will appear on the upper line. Press the
RECALL key to actually recall and activate the selected
program. ..
I The number of the selected effect program should now
be flashing on the display, indicating that the program
has been selected but has not yet been recalled (the
previous effect program is stili active). Press the
RECALL key to actually recall and activate the selected
program. The program number will stop flashing.
m C e l l o
l U
C h o E h 1
0 if the MEMORY mode is not already selected (i.e. if the
MEMORY key indicator is i]£!l lit), press the MEMORY
key to select the MEMORY mode.
/ S l a p B a s s 1
C h o ^ R h 1
The MEMORY mode can not be directly selected from
the UTILITY mode by pressing the MEMORY key. The
UTILITY mode must first be exited by pressing several
times or holding (about one second) the UTILITY key
until the UTILITY key indicator goes out.
0 Use the Aand/or Tkeys to select the number of the
desired effect program (In this example we go to
program number 10 from number 1, so only the Akey
is used). Press the Aor Tkey briefly to select the next
highest or lowest numbered program, or hold either key
down for continuous scrolling in the corresponding
direction. Faster scrolling is achieved by pressing the
opposite arrow key while holding the arrow key
corresponding ib the directbn of scrolling.
R v c p C e l l o
C h o E h l
-Flashing