Yamaha HTR-5540 - Manual (Page 51)

ADJUSTING THE PARAMETER SETTINGS FOR PRO LOGIC II MUSIC
Changing parameter settings
You can adjust the values ol PRO LOCIIC.' II Music
parameters so the sound fields are recreated accurately in
your listening room.
Adjustments should be made with the remote control.
-1
II
Select PRO LOGIC n Music.
Press /\ / \/ to select the
parameter.
PRO LOGiC II Music parameter
descriptions
m PANORAMA
Function: Turning the function on extends the front
stereo image to include the surround
speakers for wraparound effect.
Choices: OFF/ON, initial setting is OFF.
■ DIMENSION
Function: Gradually adjusts the soundfield either
towards the front or towards the rear.
Control range: -3 (towards the rear) to +3 (towards the
front), initial setting is STD (standard).
■ CT WIDTH (Center width)
Function: Adjusts the center image from all three
front speakers to varying degrees. The
larger the value, adjusts the center image
towards the main left and right speakers.
Control range: 0 (center channel sound is output only
from center speaker) to 7 (center channel
sound is output only from main left and
right speakers), initial setting is 3.
O >
m <
3J >
d o
O m
z D
El Press+/-to change the
parameter value.
□
ET Repeat steps 2 and 3 above as necessary to
change other parameters.
Note
• You cannot change parameter values when “10 MEM.
GUARD” on the SET MENU is set to ON.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. Flowever, if the power is cut for more
than one week, the parameter value you edited will
return to the factory setting. If so, edit the parameter
value again.
47