Yamaha HTR-5540 - Manual (Page 22)

CONNECTIONS
This unit is ctiiiijiix’d with 6 tiddiliontil input jticks (MAIN
left and right, CENTER, SURROUND left and right and
SUBWOOFER) for discrete multi-channel input from an
external decoder, sound processor, or pre-amplifier.
Connect the output jacks on your external decoder to the
6CH INPUT Jacks. Be sure to match the left and right
outputs to the left and right input Jacks for the main and
surround channels.
Notes
• When you select 6CH INPUT as the input source, this unit
automatically turns off the digital sound field processor, and
you cannot listen to DSP programs.
• When you select 6CH INPUT as the input source, settings of
“I SPEAKER SET” on the SET MENU do not apply (except
for “IE MAIN Lv”).
Connecting an external decoder Connecting the power supply
cords
VOLTAGE SELECTOR
■ Connecting the AC power cord
Plug in this unit to the wall outlet.
■ AC OUTLETS (SWITCHED)
U.S.A., Canada, China, Europe, Singapore and
General models..............................................2 OUTLETS
U.K. and Australia model................................1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC OUTLETS
is controlled by this unit’s STANDBY/ON (or POWER).
These outlets will supply power to any source component
connected to this unit whenever this unit is turned on. The
maximum power (total power consumption of
components) that can be connected to the AC OUTLETS
varies depending on the area which it was purchasing.
China and General models.......................................50 W
Other models........................................................... 100 W
■ VOLTAGE SELECTOR
(China and General models)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE
plugging into the AC main supply. Voltages are 110/120/
220/240 V AC, 50/60 Hz.
18