Yamaha HTR-5540 - Manual (Page 28)

BASIC PLAYBACK
ET start playback or select a broadcast station
on the source component.
Refer to the operation instructions for the
component.
Adjust the volume to the desired level.
The volume level is displayed digitally.
Example: -70 dB
Control range: VOLUME MUTE (minimum) to
0 dB (maximum)
The volume level indicator also shows the current
volume level as a bar graph.
If desired, use BASS and TREBLE. These controls
only effect the sound from the main speakers.
7.^
BASS TREBLE
Front panel
VOLUME
Remote control
Notes
• If you increase or decrease the high-frequency or the low-
frequency sound to an extreme level, the tonal quality from the
center and rear speakers may not match that of the main left
and right speakers.
• If you have connected a recording component to the VCR
OUT, or MD/CD-R OUT jacks, and you notice distortion or
low volume during playback of other components, try turning
the recording component on.
Q] Select a DSP program if desired.
Use PROGRAM <3 /1> (DSP program buttons on
the remote control) to select a DSP program. See
pages 29 to 33 for details about DSP programs.
■ BGV (background video) function
The BGV function allows you to enjoy video images
from a video source together with sounds from an audio
source. For example, you can enjoy listening to classical
music while having beautiful scenery from a video source
on the video monitor.
Select a source from the video group, then select a source
from the audio group using the input selector buttons on
the remote control. BGV selections cannot be made with
INPUT <3 /1> on the front panel.
To mute the sound
Press MUTE on the
remote control.
To resume the audio output,
press MUTE again.
\i/
• You can also cancel mute by pressing VOLUME A/v^ etc.
• During muting, the “MUTE” indicator flashes on the front
panel display.
■ When you have finished using
this unit
■ Press STANDBY/ON (POWER on the remote
control) to set this unit in the standby mode.
Front panel Remote control
Front panel Remote control
24