Yamaha HTR-5540 - Manual (Page 17)

CONNECTIONS
Before connecting components
CAUTION
Do not connect this unit or other components to the
mains power until all connections between the
components have been completed.
' Be sure all connections are made correctly, that is to
say L (left) to L, R (right) to R, “+” to “+” and to
Some components require different connection
methods and have different jack names. Refer to the
operation instructions for each component to be
connected to this unit.
' When you connect other YAMAHA audio components
(such as a tape deck, MD recorder and CD player or
changer), connect them to the Jack with the same
number labels as CD, [3], 3] etc. YAMAHA applies this
labeling system to all its products.
' After you have completed all connections, check them
again to make sure they are correct.
' The name of Jack corresponds to input selector.
■ Connecting to digital jacks
This unit has digital jacks for direct transmission of
digital signals through either coaxial or fiber optic cables.
You can use the digital Jacks to input PCM, Dolby Digital
and DTS bitstreams. To enjoy multi-channel sound ti'ack
of DVD software, etc. with DSP effect, you need to make
digital connection. All digital input Jacks are acceptable
for 96-kHz sampling digital signals.
Note
• The OPTICAL jacks on this unit conform to the EIA standard.
If you use a fiber optic cable that does not conform to this
standard, this unit may not function properly.
T3
H
m
5
O
z
(page 16)
13