Panasonic PV-V4621 - Manual (Page 8)

Initial Setup for ANT./ Cable - VCR -TV Connection
How to Connect
0
2
Connect the Cable from Antenna/Cable to the IN FROM ANT.
terminal on VCR.
Connect the OUT TO TV terminal on the rear of VCR to the ANT.
IN terminal on TV using the RF Cable (included accessory).
How to do Initial Setup
1
2
Press VCR* button for VCR
mode. Turn the TV on and set it
to channel 3.
Turn VCR on.
When VCR is turned on the first
time. SELECT LANGUAGE screen
appears.
3
SELECT language
PRESS CH A : ENGLISH
OPRIMIR CH ▼ : ESPAÑOL
APP. VCR/TV : FRANÇAIS
Press CHA to select English,
or
Press CHV to select Spanish,
or
Press VCR/TV key to select French.
When one of above keys is pressed,
SELECT CONNECTION screen is
displayed in the selected language.
If screen does not appear, check
connection between VCR and TV
and, if TV is tuned to channel 3, try
switching it to channel 4.
When you want to change the output
channel of VCR, please refer to VCR’s
Output Channel on page 13.
If wrong language is set, do “Reset All
VCR Memory Functions” steps on
page 9.
4
CABLE/DSS BOXWCR^TV
VCREGABLE/DSS BOX►TV
SELECTW SET:
EXIT : ACT I ON
Press A ▼ to select connection
“VCR^TV” and press ► to set.
CHANNEL/CLOCK AUTO SET
screen appears.
WARNING--------------------------------------------------------------------
When using “Nut type” RF coaxial cables, tighten with fingers
only. Overtightening may damage terminals.
VCRfCTÂfCLOCA I channel I
CH.^NEL/CLOCH AUTO SET
CONNECT ANTENNA CABLE
ANO IF VOO USE A CABLE
BOX. TUNE I T TO YOUH
LOCAL PBS CH THEN. . ,
PLEASE PBESS CH UP KEY
8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]