Panasonic PV-V4621 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
‘Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
5
Confirm the output channel of your cable
box or DSS receiver. Press ▲ ▼ Keys to
select the same channel as the cable box
or DSS receiver output channel. Press ►
to enter.
rvCRrc7A (CLOCK t CHANNEL 1
CHANNEL/CLOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU use A CABLE
BOX. TUNE IT TO YOUR
LOCAL PBS CH THEN. . .
PLEASE PRESS CH UP KEY
Turn on your cable box and set it to
your Public Broadcasting Station
(PBS) channel in your time zone.
If you use a DSS receiver, it must be
turned off.
6
Press CH A Key to start Channel/Clock
Auto Set operation. The Channel/Clock
Setting is performed automatically.
If the setup is completed, the following
screen appears.
POWER
VCR
VCR/TV
SELECT/
SET
A tPUNY
▼ :STOP
►:FF
ACTION
CH A/V
VCR FC/A fCLOCin CH
5/13/2001 SUN 2:20PM
DST:ON
SETTING ; CH 10
AUTO CLOCK SET
COMPLETED
If “Auto Clock Set is Incomplete"
screen appears, set the clock using
MANUAL CLOCK SET procedures
shown on page 9.
VCR
AUTO CLOCK SET IS
INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
11