Panasonic PV-V4621 - Manual (Page 27)

'Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
COmEROAl^^ASDVANCE^ Playback
When playing back recording which have been
marked using coMMERCiAt—AfllfflMiCE* feature, you
can either set VCR to automatically advance
through marked commercial blocks, or set it so that
commercials are only skipped on your command.
1
►VCR 1 C/A 1 CLOCK 1 CH
REPEAT PLAY :OFF
TIME STAMP :ON
REMOTE WARNING :ON
AUTO SHUT- OFF :ON
IDIOM/VLANGUe ; ENGLISH
VCR'S OUTPUT CH :3
SELECT : i T ►
EXIT ; ACT ION
Press ACTION
to display MENU.
irCR l»C/A~) CLCCK I CH
SET UP COMMERCIAL ADV.
&A RECRD :ON
C/A PLAYBACK AUTO
SELECT :A T
EXIT___ : ACT I ON
Press
to select C/A
and display SET UP
COMMERCIAL ADV.
VC r T“C/A~| CLOCK ! CH_
SET UP COMMERCIAL ADV,
C/A RECRD :ON
SELECT:A T SET:^
EXIT lACTlON
Press
AT
to select C/APLAYBACK
and press ► to set.
AUTO VCR will automatically advance through
marked commercial blocks recorded on the
tape and then resume playback.
MANUAL VCR will advance through commercials only
when CA/ZERO is pressed. Playback will
resume when the end mark of a commercial
block is found, or a new recording or blank
portion is detected, or after 8 minutes.
4 Press ACTION again
to return to normal screen.
PLAY
SELECT/
SET
A:PLAY
▼ :STOP
► :FF
◄ ;REW
NUMBER
keys
ACTION
CA/ZERO
ccMMfROAi^ilDUUiCE* and
are
registered trademarks of SRT, Inc.
A Jerry Iggulden invention licensed
in association with Arthur
D. Little Enterprises, Inc.
U.S.Pat. No. 5,333,091;
5,692,093: 5,696,866
other patents pending
The selection mode in step 3 remains set unless there is a power outage in which case the
original factory setting will be restored.
If playback is started in the middle of a commercial, only a single commercial is shown, or an
individual commercial is longer than 1 minute, a commercial may not be skipped.
Press FF to quickly advance through the commercial.
Part of a recorded program may be skipped over if the program portion between commercials is
less than one minute or there are frequent dark and quiet scenes during the program. To view
the portion of tape being incorrectly skipped, press PLAY while the VCR is skipping, reverse the
tape to a point just prior to where the skipping began and press PLAY again. This time the group
will not be automatically skipped. Automatic skipping will be re-enabled when the end of the
marked group is detected.
27