Timer recording using vcr pius/ system (continued), Press, To enter vcr plus+ channels – Panasonic PV-V4621 User Manual
Page 20: Press action twice, Manual vcr plus+ channel setup, Xfox, Initial setup, Channelsetup
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Timer Recording Using VCR Pius/ System (continued)
Initial Setup...
In order to use Timer Programming Using VCR Plus+ System, the Initial Setup on page 8 to 11 must
be completed for setting Clock and Channel,
ChannelSetup......
Since PlusCode numbers assigned to channels (found in TV Guide and selected newspapers) may
differ from channels in your viewing area, you’ll need to enter your local TV channel number for
each corresponding Guide Channel.
If you perform the VCRt- Channel set up procedures shown below, you will be able to perform timer
recordings using the PlusCode programming number listed in your local TV listing.
Manual VCR Plus+ Channel Setup
For [VCR-TV] or [VCR-cable box-TV] connection only.
^ cuoc'^m^Fjl Press ACTION*
to display menu.
To complete step 5 of setup, do the
following;
• Prepare a TV/Cable station line-up and
channels they are received on. Also, the
Guide channel numbers assigned to
your stations (found in TV Guide and
selected newspapers.)
• Make a 3-column chart (see sample).
Left column -> all stations you receive.
Middle column --> each station's
assigned Guide channel number from TV
Guide, etc.
Right column -> channel number on
which your TV receives the station.
SAMPLE ONLY
Broadcast or Cable
station name
Assigned Guide
channel No.
Channel No. on
which my TV
receives the station.
HBO
33
15--^
Nickelodeon
38
k CBS
04
04"\
XfOX,
11
TIME STAMP
REMOTE WARNING
AUTO SHUT-OFF
IDIOMA^UWGUE : EMQLfSH
VCR’
8
OUTPUT CH
:3
VCRr^TA fCLOci< iPCRANNEL
AHTEWWT"CSBLiE
Press
<
►
to select CHANNEL.
VCRrc/AJl^)CK
ANTENNA t CABLE
AUTO SET
CHANNEL CAPTION
WEAK SiGNAL DISPLAY : OFF
Press
AT
to select VCR Plus+
CHANNEL SETUP,
and press
P
to set.
rVCnrcTA tciScK I OumWELj
I
auto
set
____________________
Press
AT
to select MANUAL, and
press
P
to set.
To enter VCR Plus+
channels,
press ► to move cursor
to right, press
AT
to
enter number, press
<
to set, and press
AT
to
scroll up/down,
• Repeat step 5 until
list is complete.
To Make Corrections,
press
AT
and ► to move to error, then
AT
to
change, or ADD/DLT to erase number.
^iwiNEr
JlECErVE
CLEAR lACXMXT
SELECT :
at
SET:^
EXIT lACTIQN
Press ACTION twice
to end setup.
20
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]