Panasonic PV-V4621 - Manual (Page 21)

'Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
VCR Plus+ System Programming
0^F Ready Check List
□ Clock is set.
□ VCR Plus+ Setup is complete (see pages 18-20).
Press PROGA^CR+ button
1
VCRPiu»+ r^PROO 1 UST
DATE START STOP
13 SAT-:----
CR
TODAY
CATEGORY :N/A
SLP
SELECT:* * A ►
Exrr : PROG
to display PROGRAM.
>VCR Ptot I PROG~l USTi
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
SELECT:A ▼ 4
mi____ l PHQQ-
Press M^
to select display VCR
Plus+ screen.
VCRPfc«+ I P'HOG. I Li^
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
BACKSPACE ; A
Press number keys
to enter PlusCode
number and press
PROGA^CR+ button to set.
To Make Corrections,
press M repeatedly
to delete number, then
repeat step 3.
•If the PlusCode number entered begins with “0,”
skip to step 5. Display in step 4 will not appear.
LfiilL :PRQG
LISTl
OAILY(MON-FRI)
WEEKLY
SELECT : A ▼
EWD :PROG
Press
AT
to select ONCE,
DAILY(MON~FRI), or
WEEKLY record frequency
and press PROG/VCR+
button to set.
Press AW
to change category and
record speed.
Press ► to set.
Press PROGA/CR+ button
to end program.
I VCRPIust I PROG F ust
iP^ START STOP CM SPD
CANCEL :ADO/DLT
Y
SELECT
I EXIT
A ▼
PROG
SET i P
Press PROGWCR+ button
again to exit.
• Press ADD/DLT
to delete the program.
Press POWER off to set the timer.
{"TIMER” lights on Multi Function Display.)
POWER
SELECT/
SET
A:PLAY
▼ :STOP
◄ :REW
► :FF
PROG/
VCR+
NUMBER
keys
ACTION
ADD/DLT
Do normal Timer Record if...
• PlusCode number is not listed tor
program.
• program (e.g. sports event) may run
over set stop time.
See page 17 to:
• cancel a timer recording in progress.
• review, replace, or clear program
contents.
Important for DSS/Cable Box Users
• When recording via OSS, the receiver
must be left on. When recording via
cable or antenna, DSS receiver must
be off.
• When recording via a cable box,
leave box on and tuned to channel to
be recorded.
Do not overlap program times.
PlusCode numbers cannot be used to
program VCR to record DSS and
cable box channels.
Make each entry within 1 minutes or
the VCR will exit setup mode.
Once VCR Plus+ channel setup is
done, channels stay in memory. If a
power interruption occurs, VCR Plus+
channet setup may be lost. Please do
VCR P(us+ channel setup again.
Obtain unlisted PlusCode numbers by
calling 1 - 900 - 454 - 7587. Call costs
about $.95 per minute.
21