Panasonic SQ-TC520N - Manual (Page 9)

PREPARATION FOR SOFTWARE INSTALLATION
Ensure that you have installed the Panasonic CD-ROM Changer Utility and the Changer device driver to suit
your computer’s operating system before you install the Panasonic SQ-TC520N CD-ROM Changer into your
computer. {See pages 10 to 12 for details.)
1
Choose “Settings” from the “Start”
menu.
2
Open “System” with “Control
panel”.
3
Select the “General” tag.
If 4.00.950 B appears under “System;", then
you are using version B.
Devce Mancget ] Proiies) Pnfotmanw
Rc0^c(«d ta
talu
20195.0EM-CS002S16-95739
Jumper pin setting for the DMA OFF terminal
If you are using version B of Windows 95 and you
have installed SmartCD Manager ver. 3.6 or later,
then DO NOT put the jumper pin in the DMA OFF ter­
minal and install the changer. This means that Direct
Memory Access (DMA) will be on.
If, however, you do not install SmartCD Manager ver.
3.6 or later, then the CD-ROM Changer may not work
correctly. If this is the case, put the jumper pin includ­
ed into the DMA OFF terminal.
IMPORTANT;
Be sure to put the included jumper pin in the DMA OFF terminal if you are going to reinstall the Operating
System for Windows 95 from this unit.
This completes preparations for installing the software.