Panasonic NV-HS950AM - Manual (Page 45)

SYMPTOM CAUSE REMEDY
“E3” indication
flashes whenever
recording is
attempted.
Erasure prevention tab on
cassette is broken off. Use the video cassette with intact erasure
prevention tab, or cover tab hole with adhesive tape,
if original recording is no longer required.
Picture is recorded
with noise or blank
screen.
Aerial or aerial lead is
defective. Check aerial connection to VCR. See page 12.
Check your normal TV picture. If there is no picture,
check your aerial.
VCR is not correctly tuned. Re-tune VCR. See page 18-20.
A1, A2 or A3 Is selected. Select the required TV programme.
Timer recording
cannot be
performed. Clock or calendar is
incorrectly set.
Check clock and calendar. Set to present time.
(Note this is a 24 hour clock.) See page 21.
Recording start or end time
setting is incorrect. Set recording start and end time correctly.
VCR is not set for timer
recording.
Press TIMER REC after programming for timer
recording.
AV external
recordings cannot
be made.
A1, A2 or A3 is not selected. Select A1, A2 or A3 by pressing INPUT SELECT.
External AV connections are
incorrect.
Check that connections for external video and audio
source are correct. See page 38.
SYMPTOM CAUSE REMEDY
Remote controller
does not operate
correctly. Remote controller transmitter
beam is not reaching VCR. Ensure that remote controller is being pointed at
VCR and that transmitter beam is not obstructed.
Distance is too far. Use remote controller within 7 m of VCR. If this
range is not possible, replace batteries.
Batteries are exhausted. Replace batteries. Note precaution for replacement
on page 11.
Batteries are incorrectly fitted
with (+/-) reversed. Fit batteries correctly as shown on page 11.
Wrong remote control mode
has been selected.
Set to the correct remote control mode.
(See page 24.)
.c
i
45