Panasonic NV-HS950AM - Manual (Page 32)

Timer Recording
G-Code Programming
Programming is now easier than ever: simply enter the
G-Code number provided in the programme schedule
column carried by newspapers and magazines.
G-Code numbers are numbers which are assigned to
each programme listed in the TV programme schedule
carried in newspapers and TV guides. When these
numbers are entered and TRANSMIT is pressed,
the numbers are converted into the actual programming.
Preparations
• Insert a video cassette with an intact erasure prevention
tab.
•Confirm that the TV is on and the VCR viewing channel
Is selected.
• Ensure that the VCR/TV switch is set to VCR.
Operations Dispiay Symbois
1 Press G-CODE.
G-CODE
O
■XmBEI
Enter a G-Code number.
Example: 920216
IS-
Press TRANSMiT.
On screen Display
TRANSMIT
O
Programming wUh G-Cwte
9 ? 0 2 1 6 ----------
Stag__I □ a i | _______S t a r t
7 / n 15:30 1 7 - 3 0
Ifl. 10.99 Remain (SPJ
►To extend the ending time or to make any
corrections, use buttons
A ▼ ◄
If the “—” appears in the
programme position:
Select the programme
position of your VCR
which receives the TV
station you entered at
step 2 using button
A
o r ¥ .
•After several seconds
have elapsed, the
message display ' ------------------------------------
at the bottom of the OSD is replaced by the
operation guide display.
• Next time G-Code for this stations is
entered, the correct position will appear.
^Programming With G-Ci?de
9 2 0 ? 1 6 - - -
PCiS
SP
□ate Slah Stop LP
— 7M1 15:30 17:30 S
20.5« 4 16.10. && flemein (SP> 130
Input invalMj,
programme poslllon
hae not bean aafl
Press STORE to confirm.
o
•The VCR will be in the timer recording standby
mode after about 20 seconds, if STORE is not
pressed.
Notes:
•To select the desired tape speed, press SPEED button
in step 2,
•To release from the standby mode, press TIMER REC.
•When the G-Code number is used for programming, the
recording time may be slightly longer than the actual
programme time.
•When programming two or more programmes, repeat
steps 1-4.
•The procedures for checking and cancelling a timer
programme are the same as on page 35.
32