Sequential switching time, Sequential switching time table 1 – Panasonic WJ-SQ308 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Sequential Switching Time

Table 1

Signal Output Condition

Without VCR

With VCR

Sequential Switching Time

The sequential switcher’s timing can be

adjusted using the Time Control (1) when the
Time Internal/External Selection Switch (2) is
set to the INT position.

The sequential switcher's timing can be

adjusted by the timing pulse from VCR when
the Time Internal/External Selection Switch

(2) is set to the EXT position.

Note:

When the VCR is turned off, the sequence is

stopped.

Normal Sequence mode

Signal can be output sequentially by the

Signal can be output with the sequential tim-

1. Alarm/Spot Output Connec

tor

2. Alarm/Sequential Output

Connector

switching time set with the Time Control (1).

ing by the timing pulse from VTR.

Spot mode

1. Alarm/Spot Output Connec

tor

2. Alarm/Sequential Output

Connector

1. The signal is output with Spot switching.

2. The signal is output sequentially.

Alarm mode (1 input)

1. Alarm/Spot Output Connec-

1. The alarmed video signal is output from

tor

the Alarm Spot Output Connector (11).
(The spot operation is available for 1-ch -
8-ch)

2. Alarm/Sequential Output

2. The alarmed video signal is output from

Connector

the Alarm Sequential Output Connector

(10).

the Alarm Sequential Output Connector
(10).

Alarm mode (multiple input)

1. Alarm/Spot Output Connec-

1. The alarmed video signals are output

1, The alarmed video signals are output

tor

sequentially from the Alarm/Spot Output

Connector with the timing set by the Time

Control (1). (The spot or bypass operation

sequentially from the Alarm/Spot Output
Connector with the timing set by the tim

ing pulse from VCR. (The spot or bypass

is available for 1-ch- 8-ch)

operation is available for 1 -ch - 8-ch)

2. Alarm/Sequential Output

2, The alarmed video signals are output

2. The alarmed video signals are output

Connector

sequentially from the Alarm/Seq Output

Connector with the timing set by the Time
Control (1). (The bypass Operation is

available for 1-ch - 8-ch)

sequentially from the Alarm/Seq Output
Connector with the timing pulse from VCR,

(The bypass Operation is avaiiable for 1-

ch - 8-ch)

Note: The switching interval ol VCR and camera should be 0.3 seconds or more.