Panasonic CQ-C8300U - Manual (Page 60)

Installation Guide
A
WARNING
This installation information is
designed for experienced instaliers
and is not intended for non-technical
individuals. It does not contain
warnings or cautions of potential
dangers involved in attempting to
instail this product.
Any attempt to install this product in
a motor car by anyone other than a
qualified instatier could cause damage
to the electrical system and could result
in serious personal injury or death.
If your car is equipped with air bag
and/or anti-theft systems specific
procedures may be required for
connection and disconnection of the
battery to install this product.
Before attempting installation of this
electronic component contact your car
dealer or manufacturer to determine
the required procedure and strictly
follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE
MAY RESULT IN THE UNINTENDED
DEPLOYMENT OF AIR BAGS OR
ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO
THE VEHICLE AND PERSONAL INJURY.
Caution:
• This unit operates with a 12 V DC
negative ground auto battery system only.
Do not attempt to use it in any other system.
Doing so could cause serious damage.
Installation Hardware
Required Tools
No. Item Diagram Q’ty
Mounting collar 1
Hex. nut {5 mm0) 1
(D Rear support strap 1
0 Tapping screw
(5 mm0x16 mm)
. 1
(D Mounting bolt
(5 mm0) 1
0 Power connector 1
© Trim plate 1
Lock cancel plate 2
You’ll need a screwdriver, a 1.5 V AA battery, and
the foilowing:
Eiectrical tape Side-cut 1 2 V D C
Test bulb pliers
60
CQ-C8400/8300/8200/81D0U