Available discs, Cq-c8400u, Cq-c8300u – Panasonic CQ-C8300U User Manual
Page 28: Caution, Note, Cq-c84g0/830o/8200/8100u, O press [^: eject, Before disc playback, Disc insert, When cd is in the player
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Before Disc Playback
CQ-C8200U/CQ-C8100U cannot play MP3/WMA files.
Available Discs
CD-DA
I?—
i]>ID
SDiilSr
(CD-TEXT is only for CQ-C8400U/CQ-C8300U.)
■ MP3/WMA
CQ-C8400U
CQ-C8300U
iiHIl
mMi
__
:S
ii№n
Caution:
• 3 " (8 cm) CD is not available for this unit, so
do not insert it.
• Do not use irregularly shaped discs.
• Do not use discs that have a seal or label
attached.
• To avoid damaging the front panel, do not push
it down or place objects on it while it is open.
• Do not pinch your finger or hand in the front
panel.
• Do not insert foreign objects into the disc slot.
Note:
• The power will be turned on automatically when
a disc is loaded.
• A disc which has both CD-DA data and
MP3/WMA data on it may not be reproduced
normally. (For example, it may be reproduced
without sound.)
• Refer to the section on “Notes on MP3/WMA”
(page 36) and “Notes on Discs” (page 58).
This instructions on this page are followed for both
CD-DA playback and MP3/WMA playback.
28
CQ-C84G0/830O/8200/8100U
Disc Insert
o
Press [^:
eject] (OPEN).
If there is a disc loaded, ^
the disc will be ejected.
A: eject] (OPEN)
the main unit, hold it as shown in the figure, and
refrain from putting any of your fingers into the
disc's center hole.
Note:
• It may take some time to start playing.
• Playback will start automatically after recognizing
the data of the loading disc.
E J E ----------
Wi
'4
READING
Q
m
№
^
__________
j
CQ-C8400U
CQ-C8300U
When CD is in the Player
Press
[SOURCE]
to select the CD (MP3/WMA)
player mode and playback starts.
Disc Eject
O
Press [^: eject].
The disc will be ejected after the front panel fully
opens.
©Take adisc.
©Press
[ A :
eject]
again to close.
Note;
• If no operation takes place within 20 seconds or
so after the panel has opened, the panel will close
automatically.