Case 1: twin lead cable only, Case 2: twin lead & coaxial cables, Case 3: two twin lead cables – Panasonic PV-840F User Manual
Page 5: Case 1: screw & plug type terminal, Case 2: screw type terminal, Case 3: double screw type terminal, I case 4: complex tv terminal, Between ant, and vcr, Between vcr and tv
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
Between ANT, and VCR
Case 1: Twin Lead Cable Only
To VCR Terminal
From Antenna
(Flat) Twin Lead
300 Ohm Cable
300-75 ohm
T ransformer
(not supplied)
Case 2: Twin Lead & Coaxial Cables
-------- ^____________
^==£33
(Round) 75 Ohm
coaxial Cable
UHFA/HF Band Mixer
(not supplied)
To VCR Terminal
Case 3: Two Twin Lead Cables
-------------------
300-75 ohm
Transformer
(not supplied)
To VCR Terminal
If your TV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal loss.
2
Between VCR and TV
Case 1: Screw & Plug Type Terminal
UHFA/HF Band
Separator
(not supplied)
RF Coaxial Cable
VHF
UHF
Case 2: Screw Type Terminal
TV
75-300 ohm
Transformer
(not supplied)
=£33
Case 3: Double Screw Type Terminal
UHF/VHF Band
Separator
(not supplied)
VHF
UHF
I Case 4: Complex TV Terminal
TERMINALS ON BACK OF TV SET
Split out
ANT2
Connect to one of the ANT terminals and
select the same antenna number on the TV.