Panasonic PV-840F - Manual (Page 14)

Multi-Brand Control Feature
The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
1
Find your TV, Cable or OSS Receiver Brand
Code Number on following page.
Setup for TV Setup remote.
Hold down TV and enter code
with NUMBERED keys.
Hold down DSS/CABLE and
enter code with NUMBERED keys.
• For code too or greater, press the
too key first, then remaining digit.
E.g. for 102, press 100, then press 2.
3 Confirm code entry.
Press POWER to turn
selected unit ON or OFF.
• See table below for list of
controllable functions in each mode,
Please repeat Multi-Brand Control setup after replacing remote
control batteries.
The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
Q StO
O © ©
© © ©_
© © ©
00©
Using the Multi-Brand Control
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
3 POWER
p TVor
DSS/ CABLE
2 NUMBERED
keys
Available
M o d e - ^ - S u t t O T ^
VCR TV CABLE/ DSS
V C R All Functions VOL UP/DOWN
T V VCFim/, PLAY, STOP
FF, REW, PAUSE,
SLOW. REC/TIME,
SPEED, COUNTER
RESET, ZERO/ 1 MIN
POWER, INPUT,
NUMBERED keys,
ENTER, CH UP/ DOWN,
VOL UP/DOWN
CABLE/ DSS VCR/TV, PLAY, STOP, FF,
REW, PAUSE. SLOW,
REC/riME. SPEED,
COUNTER RESET,
ZERO/ 1MIN
VOL UP/ DOWN POWER, ENTER,
NUMBERED keys
(except lOOkey),
CH UP/ DOWN
In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
14
For assistance, call 1-800-211-PANA{7262).