Tuning the tv to your vtr, Operations, Note – Panasonic NVHD650 User Manual
Page 9: Nv-hd650a
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning the TV to your VTR
Connections
Tuning the TV to your VTR
NV-HD650A
Operations
1,3
same way that you watch TV broadcasts.
If you have connected the VTR to the TV through the video
and audio sockets then you do not need to follow the
procedure mentioned below.
CO
1
CZ)
Turn on the TV and VTR.
TEST
SIGNAL
To generate a test pattern, set TEST
SIGNAL to ON.
Set the TV to an unused position which you
wish to use for your video playback.
TEST
SIGNAL
Set TEST SIGNAL to OFF.
Note:
The test signal is transmitted on video channel AU37. If you
are encountering interference from a TV broadcast on this
video channel, you may readjust to another free channel
(AU31 -43) by using the
CH ADJ.
screw which is located on
the rear of the VTR.
Please note that if the
CH ADJ.
screw is used then you will
have to retune your TV to the test signal as in item 2 to 4
above.