Panasonic KX-F50BA User Manual
Panasonic, Operating instructions, Kx-f50ba
This manual is related to the following products:
Table of contents
Document Outline
- Panasonic
- WARNING
- Introduction
- Accessories
- Installation Connections
- The Buttons and Indicators
- Precaution
- 1
- Upper guide plate (green plate)
- Paper- Guide marks
- Lower guide plate
- Selector Settings
- Turning the Power Switch On
- Recording an Outgoing Message (OGM)
- Programming Functions
- Programming Phone Numbers for Automatic Dialing
- Before Transmitting Documents
- Transmitting Documents
- 1
- Insert the documents FACE DOWN.
- Press the MONITOR button or lift the handset.
- Dial the phone number.
- OR
- Press the AUTO button, then press the desired station number (“00” through “19”) by using the dial keypad.
- OR
- Press the direct call station.
- Press the START/COPY button when a fax tone is heard.
- To stop transmission;
- Transmitting documents using the REDIAL button
- 1
- Press the MONITOR button or lift the handset.
- Press the REDIAL button.
- Press the START/COPY button when a fax tone is heard.
- To stop transmission:
- Receiving Documents and/or Voice-Messages
- Receiving mode
- Manual reception
- Press the RECEIVE MODE button to set to the TEL mode.
- When the phone rings, lift the handset to answer the call.
- Press the START/COPY button to receive documents, and then place the handset on the cradle.
- Press the MONITOR button or lift the handset while transmitting or receiving the documents.
- When the other party answers, start speaking using the handset.
- Receiving a request for voice contact
- Making Copies
- Operating as an Answering Device
- 1
- Press the PLAYBACK/PAUSE button to play back the tape to the end of the messages you want to save.
- Press the PLAYBACK/PAUSE button again to stop the tape.
- Press the REW and PLAYBACK/ PAUSE buttons together.
- Press the MEMO/2WAY button until a beep is heard.
- Speak toward the microphone from approximately 20 cm (8 inches) away.
- When the recording is finished, press the MEMO/2WAY button again.
- Recording a 2-way conversation
- 1
- Continue your conversation.
- To stop recording, press the MEMO/2WAY button again.
- Monitoring incoming calls
- Making and Answering Voice Calls
- Polling
- Setting the polling password
- Press the PROGRAM button.
- Press then press “16” for the polling password setting.
- Enter the same polling password of 4 digits using the dial keypad.
- Press the SET button to store the programming in memory.
- Press the PROGRAM button to end the operation.
- Press the desired direct cal! station key.
- Using speed dialing or manual dialing:
- Setting the polling password
- Setting the Main Password
- Operating as an Answering Device from a Remote Phone
- 1
- Press “7” to start re-recording after hearing the beeps that indicate the number of recorded messages.
- After hearing a long beep, speak clearly and loudly for up to 16 seconds.
- When you finish, press “9”.
- Skipping the OGM for ICM recording
- Other Features
- Printing Reports and Lists
- System Programming Functions
- Service Functions
- Maintenance
- Troubleshooting Guide