Panasonic KX-F50BA - Manual (Page 72)

. ■ -. .,. . v . ■ ' -V.* ■ ‘■. S ‘ * ,■■
Answering Device & Telephone
PROBLEM CAUSE & REMEDY
The unit does not work when any
button is pressed.
•Turn the POWER switch off, then turn it on
again.
The unit has been set to the
TAD/FAX mode, but no
voice-messages have been recorded.
•The tape is not installed properly or is
broken (cut, worn out or twisted). Install the
tape or replace it with a new one.
When the tape is played, the sound
level is low or nothing can be heard. •Raise the sound level using the VOLUME
control.
•Clean the head of the cassette deck
compartment. See page 4-10.
1 have played back all the recorded
messages and 1 want to record the
next call after the last message.
•Leave the unit as it is after hearing the
messages.
1 cannot retrieve recorded messages
from a remote phone.
•Make sure that you use your REMOTE TAD
ID number correctly.
•When you press your REMOTE TAD ID
number, press the buttons firmly.
Some voice-messages have not been
fully recorded.
•Set the calling party control (CPC) to “B".
See page 4-6.
When a caller hangs up after leaving
a message, the tape does not stop.
•VOX TIME should be set to 4 seconds. See
page 4-9.
The unit does not ring. •Set the RINGER volume selector to the
HIGH or LOW position.
The ALARM Indicator
PROBLEM CAUSE & REMEDY
The indicator flashes after
transmission. •A transmission error has occured. Try again.
The indicator lights. •Confirm that the covers of the unit are
closed firmly.
•Your OGM is not recorded. See page 1-13.
The indicator lights during
transmission. •A document more than 600 mm (23%") is
being transmitted.
•A document is jamming. Remove it.
•Connect the unit to a line that does not have
special telephone service such as call
waiting.
4-13