Re-recording an outgoing message, When you finish, press “9, Skipping the ogm for icm recording – Panasonic KX-F50BA User Manual
Page 56: Press “0” while the ogm is playing
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
f'
' ^ . • ^ V ' 4 „ ; V ' ; ' ■ ; ; V
Re-recording an outgoing message
You can change the content of your OGM from a remote telephone.
1
-•y> iifv/ .iV-Д -*4.- -
€ФШ
Press “7” to start re-recording after
hearing the beeps that indicate the
number of recorded messages.
■■
-'-i
' ■"'
■■' .-,' •' -T.'Is ^
I'
''''
.
’ч" -J *♦ ’ "■
■'*>"1^*', Y'-кЧ
f
' W''
"i.' >■■ *'■'
. ,4W,. .* .•,■'■ 4S;,
::>.;V;-
^ ^ ‘ “
After hearing a long beep, speak clearly
and loudly for up to 16 seconds.
When you finish, press “9”.
The new OGM is played back to confirm the
change.
Note:
If you pause for over 2 seconds while recording, the unit beeps and stops the
OGM recording. In such a case, repeat from step 1 within 10 seconds.
Skipping the OGM for ICM recording
You can leave a message on your unit without listening to your OGM.
You need not enter your REMOTE TAD ID.
Press “0” while the OGM is playing.
After hearing a long beep, speak clearly and
loudly to leave your message.
3-9