Panasonic KX-F50BA - Manual (Page 71)

Troubleshooting Guide
Facsimile
>■ V;
•fc 1 t V k * "^ ■
■:
.
PROBLEM CAUSE & REMEDY
1 cannot receive documents
automatically.
•Make sure recording paper is installed
properly.
•Make sure the RECEIVE MODE of the
unit is set to TAD/FAX or FAX mode and
not to TEL mode.
•Shorten your OGM.
•Set the vox sensitivity (VOX SENSE) to
“LOW”. See page 4-9.
Recording image is faint and 1 cannot
read it well.
•The sender transmitted a faint document.
Request him to transmit a more clear
document (e.g. copied one) again.
The other party complains that the
letters on the document are distorted.
•If your line has special telephone service
such as call waiting, it may have been
activated by another telephone call.
Connect the unit to a line that does not
have such service.
•Be sure another telephone is not
connected to the same line as your unit.
The START/COPY indicator flashes for
about 40 seconds after the unit
receives a call automatically, but
nothing is recorded.
•The caller hangs up during or
immediately after playing back your
OGM. This may occur if the disconnect
signal is not transmitted from the central
office.
When 1 receive or copy a document that
has a dark background or contains
photographs, the unit produces a high
pitched noise.
•This is quite normal.
The unit does not operate properly. •Turn the POWER switch off, then turn it
on again.
Problems when receiving international
facsimiles.
•Shorten your OGM to 10 seconds or less.
•FAX RX SPEED may need to be set to
4800 bps. See page 4-4.
The recording paper does not move
during copying or receiving.
• Make sure that the recording paper is
correctly inserted between the upper
guide plate and lower guide plate.
• If the recording paper is wrapped around the
roller, turn off the power and remove the
paper. Cut off any part of the paper that is
creased, and reinsert the paper between
the guides.
4-12