Panasonic OMNIVISION VHS PV-M2058 - Manual (Page 32)

Unit and Cassette Information
[ Maximum Record/Playback Time ]
Only use tapes with the IVBSI mark in this unit.
Tape Speed
Setting
Type of Video Cassette
T60 T120 T160
SP
(Standard Play)
1 Hour 2 Hours
2 Hours
40 minutes
LP
(Long Play)
2 Hours 4 Hours
5 Hours
20 minutes
SLP
(Super Long Play)
3 Hours 6 Hours 8 Hours
( DST. (Daylight Saving Time) ]
Your Combination VCR can be set to
automatically adjust the clock for Daylight Saving
Time, (page 9.)
Spring (First Sunday in April)
When set to DST:ON, the Combination VCR will
automatically set the clock ahead one hour.
Autumn (Last Sunday in October)
When set to DST:ON, the Combination VCR will
automatically set the clock back one hour.
• If your area does not observe Daylight Saving Time,
select DST: OFF.
• Keep these time changes in mind when programming
the Combination VCR for timer recordings.
[
_________ Head Cleaning_________ J
Your Combination VCR will not normally require
head cleaning, however, the heads may become
clogged when playing an old or damaged tape.
Head Clog Sensor
If head cleaning becomes
necessary, the
Combination VCR will
display the screen shown
to the right during
playback of a video tape.
To exit this screen, press
PLAY on the remote control or Combination
VCR.
• Use “dry” type head cleaning cassette* only.
• Be sure to follow the cleaning cassette instructions
carefully. Excessive use of a cleaning cassette can
shorten head life.
• If using a head cleaning cassette does not solve the
problem, contact your nearest Factory Service Center
or authorized Service Center. (See page 34.)
• Cleaning cassette part No. NV-TCL30PT is
recommended.
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OH REFER TO MANUAL
END:PLAY KEY
[ Erase Protection (Record Tab) )
Cassettes have a record tab to ensure that recordings
are not accidentally erased.
To prevent accidental if^^k
erasure, break off the tab (-4,—
with a screwdriver. I _____________
To record again, cover the
hole with cellophane tape.
( Reset all Combination VCR Memory Functions '
Use when moving the Combination VCR to a new
location, or if a mistake was made in the One Time
Setup section.
• Make sure a tape is not inserted in the Combination VCR.
1) Press POWER to turn the Combination VCR on.
2) Hold down both the PLAY and REWIND buttons
on the Combination VCR for more than 5
seconds.
• The power will shut off.
3) Turn the power back on and perform the One
Time Setup section on page 8.
Product Specifications
Display
Picture Tube:
VCR
Video Recording System:
Audio T rack:
Tuner:
Broadcast Channels:
CABLE Channels:
FM Radio
Band range:
20 inch measured diagonal 90°
deflection Picture Tube
2 rotary heads helical scanning
system
4 rotary heads helical scanning
system
1 track
VHF2-13, UHF 14-69
Midband A through I (14-22)
Superband J through W (23-36)
Hyperband AA-EEE (37-64)
Lowband A-5-A-1 (95-99)
Special CABLE channel 5A (01)
Ultraband 65-94, 100-125
87.5-108.1 MHz
General
Power Source:
Power Consumption:
32
120V AC, 60 Hz
Approx. 110 watts (Power on)
Approx. 5 watts (Power off)
EIA Standard NTSC color
1 piece
2 pieces
4rF~104°F{5“C-40°C)
10%-75%
50.6 lbs. (23 Kg)
20-5/16" (W)X 19-7/8” (H)X
19-1/16" (D)
515 (W) X 505 (H) X 484 (D) mm
Note: Designs and specifications are subject to change
without notice.
Television System:
Speaker:
Operating Temperature:
Operating Humidity:
Weight:
Dimensions: