Panasonic OMNIVISION VHS PV-M2058 - Manual (Page 10)

On-Screen Displays (OSD)
^Important: If the remote control POWER, CH AT ,
ACTION, PROG, INDEX, ON-TIMER,
R-TUNE, FM/TV and ADD/DLT button
does not work when pressed, press the
TVA/CR button on the remote and try
the button again.
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear for a few
seconds on-screen.
(Some station names may
also appear if Channel
Caption is set. See page 21.)
When a function button is
pressed (PLAY, FF, etc.), the Combination VCR
mode will be displayed.
• When a recording is started, both REC and
the channel number will appear together.
Menu Screen
1
Press ACTION* to
display the MAIN
MENU.
2
Press AT and
ACTION to make your
selection (see page 8).
• To get the most from each feature, please read
the Operation Manual before attempting any
operation.
VCR Status & Clock Display
Press DISPLAY to display and remove the
overlay shown below.
LTOGBSE
® ® w
SELECT : A T ^ ► KEY
SET
: ACT I ON KEY
Function Current Channel Caption
Status Time (See page 21.)
Rec Time
(OTR mode
oniy see
page 17.)
RK 12:00AM ABC f
“0:25 -0:12:34
> STEREO«- SP
»SAP
MONO
/
N
-
Receivable Broadcast
Types (See page 27.)
Tape Speed
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
Tape Counter
If no active channels are
found for CHANNEL
MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Recording or
set the On-Timer and the
Clock is not set...
(see pages 8, 9 }
If you press REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 17.)
if you press STOP
during a Timer
Recording...
(see page 19.)
If you press PLAY, FF,
REW, or REC on the
remote control or the
Combination VCR without
a cassette inserted...
(see pages 16,17.)
If the Combination VCR is
not in Stop mode or a
cassette with record tab is
not inserted two minutes
before a Timer Recording
is about to begin...
(see pages 18,19.)
If head cleaning becomes
necessary while playing
back a tape...
(see page 32.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
CHECK CASSETTE
RECORD TAB
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE PREPARE
FOR T IMER REC
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up
in Play mode, or when the selected channel
has no broadcast signal with the “Blue Back
ON/OFF Feature” (page 22) set to ON, the TV
screen will turn solid blue.
10
If you press a function
button other than
STOP/EJECT or POWER
while the Combination VCR
is in VCR Lock mode...
(See page 23.)
VCR LOCK ACTIVATED