Panasonic OMNIVISION VHS PV-M2058 - Manual (Page 28)

VCR Plus+ Setup
Easy Taping.
•Important: If the remote control POWER, CH AT , ACTION, PROG, INDEX, ON-TIMER, R-TUNE, FM/TV and ADD/DLT
button does not work when pressed, press the TVA/CR button on the remote and try the button again.
VCR PIUS+ programming allows you to set most items of a timer recording by simply entering a special code (PlusCode)
found In TV GUIDE magazine as well as the TV listings in selected newspapers. In order for your Combination VCR to do a
VCR Plus+ recording, or a timer recording of cable stations, some setup is required.
At first, choose your Connection
Type.
(Then, follow the instructions under the diagram.)
Connection Type A
]
Cabla/
Antenna
RF Coaxial Cabla Back of
( not njppUeb) Combination VCR
viKoiN MjaaiM
Front of
Combination VCR
If your system looks like this, do the
following,
1. Complete the “Cable Box Setup”
section at right.
2. Skip page 29 and go directly to page
30 for VCR Plus+ Programming.
I Connection Type B ]
Back ot
Combination VCR
From Antenna
or Cabie
Cable/
Antenna
RF Coaxial Cable
(not supplied)
If your system looks like this, do the
following.
1. Skip the “Cable Box Setup”
section at right and turn to page 29.
2. Complete the “VCR Plus+ Channel
Setup” section on page 29.
3. Turn to page 30 for VCR Plus+
Programming.
VCR Plus-i- and PlusCode are ^
trademarks of Gemstar Development
Corporation.
The VCR Plus-i- system is manufactured
under license from Gemstar Development
Corporation.
28
Cable Box Setup
For Connection Type A (see left) only
1
Press ACTION* to display
the MAIN MENU.
2
Press to select
“CH,” and then press
ACTION to display the SET
UP CHANNEL screen.
SELECT : A T ^ ► KEY
SET lACTION KEY
3
Press AT to select “CABLE
BOX SET UP,” and then
► to set.
------- SET UP CHANNEL
ANTENNA : CABLE
ALTTO SET
CHANNEL CAPTION
VCR PIUS+ CH SET UP
SELECT:A ▼ KEY
SET ;► KEY
END
:ACT I ON KEY
4
Press AV and to select
“YES” or “NO,” and then
press ► to set.
Select YES if all channels are
received via the cable box
fconnection “A” at left). Then, go
to step 5.
Select NO if your cable connection “B” at left. Press
ACTION to exit and turn to page 29.
ARE YOU US ING
A CABLE BOX?
YES
ITBl
SELECT:* ▼ KEY
SET :► KEY
END
: ACTION KEY
Press AT to select Cable
box output channel number,
and then press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using AudioA/ideo jack
connection for your cable box,
select and set “VIDEO OUT as
the output channel.
ENTER CABLE BOX OUTPUT
CHANNEL
EH
SELECT:* V KEY
YOUR TV IS RECEIVING
THE OUTPUT OF CABLE BOX
CH 01
This display appears for
5 seconds. (Channel
shown is example only)
G Press ACTION twice to end the setup and return to
the normal screen.
Go directly to VCR Plus+ Programming on page 30.